Installing The Intel®Integrated Raid Module; Figure 57.Installing The Barrel Standoff - Intel R1000EP Series Service Manual

Server System Features
Installing the Intel®Integrated RAID Module
To install the RAID module, follow these steps:
1. Turn off the power to the system, all drives, enclosures, and system components. Remove
the power cord(s).
2. Remove the server cover. For instructions, see your server system documentation.
3. Insert the three barrel standoffs into the matching holes in the server board.
4. Attach the RAID to the matching server board connector, and press the module card firmly to
engage the barrel standoffs installed in step 3. Press down gently but firmly to ensure that the
card is properly seated in the connectors, and then insert the four pin standoffs into the barrel
standoffs respectively. The Intel
36

Figure 57.Installing the Barrel Standoff

RAID Module is shown for illustrative purpose see below.
®
®
Intel Server System R1000EP Service Guide