Austin Hughes Electronics Cyberview D-117 User Manual page 7

Install JVM on Client system
IP-KVM switch was accessed using a standard JAVA enabled web browser. You must
install Sun JVM 1.4.2 or above to your client system.
Note: At a minimum you must have Internet Explorer 6.0 or Netscape 7.0 or Molliza 1.6
(and above) installed on your client computer.
Connect IP-KVM switch via Web
Using the HTTP protocol or a secure encrypted connection via HTTPS and entering the
configured IP address of IP-KVM switch into your web browser to connect IP-KVM switch.
The factory default settings are:
Username
Password
Changing default username and password to user specific values is strongly recommended
and can be done on the User Management page (see the Section called Users and Groups
in Chapter 6).
Control servers via Remote Console
The Remote Console is the redirected screen, keyboard and mouse of the remote host
system to which IP-KVM switch is installed. The Remote Console will behave exactly the
same way as if you were sitting directly in front of the screen of your remote system. That
means that both the keyboard and mouse can be used in the usual way. Open the console
by selecting the preview picture on the main site of the HTML front end. Figure 1-1 shows
the top of the Remote Console.
super
pass
6 / 77
KVM over IP Module