Austin Hughes Electronics Cyberview D-117 User Manual page 38

To create a CDROM image file, copy the contents of the CDROM to a file. You can use
the following command:
dd [ if=/dev/cdrom ] [ of=/tmp/cdrom.image ]
dd reads the entire disc from the device /dev/cdrom, and saves the output in the
specified output file /tmp/cdrom.image. Adjust both parameters exactly to your needs
(input device etc.).
MS Windows
To create the image file, use your favorite CD imaging tool. Copy the whole contents of
the disc into one single image file on your hard disk.
For example, with "Nero" you choose "Copy and Backup". Then, navigate to the "Copy
Disc" section. Select the CD ROM or DVD drive you would like to create an image from.
Specify the filename of the image, and save the CD ROM content in that file.
Figure 6-13. Nero selection dialog
37 / 77
KVM over IP Module