Keyboard, Mouse And Video Configuration; Ip-Kvm Switch Keyboard Settings; Remote Mouse Settings - Austin Hughes Electronics Cyberview D-117 User Manual

IP auto-configuration
With this option, you can specify whether the IP-KVM switch should get its network
settings from a DHCP or BOOTP server. For DHCP, enter "dhcp", and for BOOTP
enter "bootp". If you do not specify any of these, the IP auto-configuration is
disabled and subsequently you will be asked for the following network settings.
IP address
The IP address the IP-KVM switch. This option is only available if IP
auto-configuration is disabled.
Net mask
The net mask of the connected IP subnet. This option is only available if IP
auto-configuration is disabled.
Gateway address
The IP address of the default router for the connected IP subnet. If you do not have
a default router, enter 0.0.0.0. This option is only available if IP auto-configuration is
disabled.

4.2 Keyboard, Mouse and Video configuration

Between the IP-KVM switch and the host, there are two interfaces available for
transmitting keyboard and mouse data: USB and PS/2. The correct operation of the
remote mouse depends on several settings which will be discussed in the following
subsections.

4.2.1 IP-KVM switch keyboard settings

The IP-KVM switch settings for the host's keyboard type have to be corrected in order
to make the remote keyboard work properly. Check the settings in the IP-KVM switch
Web front-end. See section 6.5.2 for details.

4.2.2 Remote Mouse Settings

A common seen problem with KVM devices is the synchronization between the local
and remote mouse cursors. The IP-KVM switch addresses this situation with an
intelligent synchronization algorithm. There are two mouse modes available on the
IP-KVM switch:
Auto mouse speed
The automatic mouse speed mode tries to detect the speed and acceleration
settings of the host system automatically. See the section below for a more
detailed explanation.
Fixed mouse speed
This mode just translates the mouse movements from the Remote Console in a
way that one pixel move will result in n-pixel moves on the remote system. This
13 / 77
KVM over IP Module