Austin Hughes Electronics Cyberview D-117 User Manual page 43

KVM over IP Module
Navigation Buttons
Connect/Disconnect
To establish the drive redirection please press the Connect button once. If all the settings
are correct, the status bar displays that the connection has been established, the Connect
button is disabled and the Disconnect button is enabled.
On an error, the status line shows the error message. The drive redirection software tries to
lock the local drive before it is redirected. That means that it tries to prevent the local
operating system from accessing the drive as long as it is redirected. This may also fail,
especially if a file on the drive is currently open. In the case of a locking failure, you will be
prompted if you want to establish the connection anyhow. This should not be a serious
problem when the note above is respected. If the write support is enabled, a drive which is
not locked might be damaged by the Drive Redirection.
With the Disconnect button, a connection via Drive Redirection connection is stopped.
Exit/Hide
If the Exit button is pressed, the Drive Redirection software is closed. If a Drive Redirection
connection is active, the connection will be closed before the application terminates.
Using the Hide to Tray button the application is hidden, but not terminated completely. That
means that an active connection will be kept active until it is closed explicitly. You can
access the software by its tray icon. The tray icon also shows whether a connection is
established or not. A double click on the icon shows the application window, or with a right
click you may access a small menu
42 / 77