Initial Ip Configuration - Austin Hughes Electronics Cyberview D-117 User Manual

1.1 Initial IP configuration

In factory default, DHCP mode is disabled (IP auto configuration = None), and the IP
settings are as below:
IP address
Subnet mask
Default Gateway
If DHCP mode is enabled (IP auto configuration = DHCP), the IP-KVM switch will try
to contact a DHCP server in the subnet to which it is physically connected. If a DHCP
server is found, it may provide a valid IP address, gateway address and net mask.
Before you connect the device to your local subnet, be sure to complete the
corresponding configuration of your DHCP server. It is recommended to configure a
fixed IP assignment to the MAC address of the IP-KVM switch. You can find the MAC
address labeled on the bottom side of the metal housing.
IP-KVM switch Setup Tool
If this initial configuration does not meet your local requirements, use the setup tool to
change the configurations to your needs. The setup tool PSetup can be found on the
CD ROM delivered with this package. You can follow the procedures described below.
1. DHCP
If you have installed the IP-KVM switch on a network that enables DHCP, you can
use the PSetup to find out the IP-KVM switch's IP.
(1) Plug Ethernet cable to IP-KVM switch. IP-KVM will get an IP via DHCP.
(2) Using PSetup (run PSetup.exe) to look for IP-KVM.
a. Select MAC address which label on bottom of IP-KVM switch
b. Click Query Device
192.168.1.22
255.255.255.0
None
4 / 77
KVM over IP Module