Displaying Information About The Hmi Device; Changing Monitor Settings - Siemens SIMATIC HMI KP300 Basic mono PN Operating Instructions Manual

5.2.3

Displaying information about the HMI device

Menu commands in the "Info/Settings" menu
The following table shows the menu commands in the "Info/Settings" menu:
Menu item
Device Info
Network Info
Version Info
License Info
Procedure
Proceed as follows:
1. Switch to "Info/Settings" menu on the HMI device.
2. Select the desired menu command.
3. Press <ESC> or <ENTER> to go back to the higher-level menu.
5.2.4

Changing monitor settings

Procedure
Proceed as follows:
1. To change the contrast:
2. To enter the display time duration of the Loader prior to project start:
Basic Panels
Operating Instructions, 04/2012, A5E02421799-03
Information contained there
HMI device name
Size of the internal flash memory in which the HMI device image and project
are stored The size of internal flash memory is not equivalent to application
memory available for a project.
IP address, MAC address and name of the HMI device.
If the name does not fit in a row, the name is abbreviated and marked with
"...".
Version of the HMI device image
Version and release date of the Boot loader
License provisions
– Switch to "Info/Settings > Contrast" menu on the HMI device.
– User the cursor keys <Up> and <Down> to change the contrast and confirm with
<ENTER>.
– Switch to "Info/Settings > Logon/Settings > Startup Delay" menu on the HMI device.
– Activate the list with <ENTER> and enter the display time duration in seconds.
Value range: 0 to 60
– Confirm with <ENTER>.
Note
Immediate start of the project with a delay time of 0 seconds
The project starts without delay if a delay time of 0 seconds is set. It is then no longer
possible to call the Loader after switching on the HMI device. To handle this situation,
you need to configure an operating element with the "Close project" function.
Configuring the HMI device
5.2 Configuring KP300 Basic
83