Enabling A Data Channel - Siemens SIMATIC HMI KP300 Basic mono PN Operating Instructions Manual

Configuring the HMI device
5.2 Configuring KP300 Basic
5.2.5

Enabling a data channel

You must enable at least one data channel to transfer a project to the HMI device.
Note
After having completed the project transfer, you can protect the HMI device against
unintentional overwriting of project data and of the HMI device image by locking all data
channels.
Procedure
Proceed as follows:
1. Switch to "Info/Settings > Logon/Settings > Transfer / Network" menu on the HMI device.
2. Using the <<Up> and <Down> cursor keys, select the desired mode under "Channel 1:
3. Confirm the selection with <ENTER>.
Note
If automatic transfer is activated, the HMI device can be set remotely to transfer mode by
a configuring PC or programming device.
84
PROFINET".
– "Enable (rem.on)": Activates the data channel and also the automatic transfer
– "Enable (rem.off)": Activates the data channel without automatic transfer
– "Disable": Deactivates the data channel
Operating Instructions, 04/2012, A5E02421799-03
Basic Panels