Siemens SIMATIC HMI KP300 Basic mono PN Operating Instructions Manual page 92

Commissioning a project
6.4 Transfer
Procedure (WinCC flexible)
Proceed as follows:
1. On the configuring PC, select the "Transfer settings" command from the "Project >
2. Select the HMI device in the left area of the dialog.
3. Select the type of interconnection for the HMI device and the configuring PC.
4. Set the transfer parameters in the right area of the dialog.
5. Start the transfer in WinCC flexible by selecting "Transfer".
Procedure (WinCC)
If you are loading a project on an HMI device, the "Advanced loading" dialog is automatically
opened. You configure the appropriate interface parameters in this dialog.
For further information, refer to the documentation on WinCC.
Proceed as follows:
1. If you want to load a project simultaneously on several HMI devices, use multiple
2. Select the "Load to device > Software" command in the shortcut menu of an HMI device.
3. When the "Advanced loading" dialog appears, configure the "Settings for loading":
4. Check the displayed default settings, and edit these if necessary.
5. Click on "Load".
Result
The project is available on the HMI device following successful transfer. The transferred
project is started automatically.
92
Transfer" menu in WinCC flexible.
The "Select devices for transfer" dialog opens.
Set the connection parameters.
The configuring PC checks the connection to the HMI device. The project is transferred to
the HMI device. An error message is displayed on the configuring PC if the connection is
not available or disrupted.
selection to select all the desired HMI devices in the project tree.
– Select the interface via which the project will be loaded.
– Configure the corresponding interface parameters.
– Click on "Load".
You can open the "Advanced loading" dialog at any time via the menu command
"Online > Advanced loading to device..."
The "Load preview" dialog" opens. The entire project is compiled at the same time. The
results is displayed in the "Load preview" dialog.
Operating Instructions, 04/2012, A5E02421799-03
Basic Panels