Siemens SIMATIC HMI KP300 Basic mono PN Operating Instructions Manual page 98

Commissioning a project
6.5 Backup and restore
Procedure – restoring
Proceed as follows:
1. On the configuration PC, select the "Communication settings" command in the menu
2. Select the type of HMI device.
3. Select the type of connection between the HMI device and the configuration PC.
4. Set the connection parameters.
5. Close the dialog with "OK".
6. Select the "Restore" command in the menu "Project > Transfer" in WinCC flexible.
7. Select the "*.psb" backup file to be restored from the "Open" field.
8. Set "Transfer" mode on the HMI device.
9. Start the restore operation in WinCC flexible with "OK" on the configuration PC.
Result
When the restore is successfully completed, the data backed up on the configuration PC is
now on the HMI device.
98
"Project > Transfer" in WinCC flexible.
The "Communication settings" dialog box opens.
The "Restore Settings" dialog opens.
You can see the HMI device for which the backup file was created and the type of backup
data the file contains.
If automatic transfer mode is enabled on the HMI device, the device automatically sets
"Transfer" mode when a restore operation is initiated.
Follow the instructions in WinCC flexible.
A status view opens to indicate the progress of the operation.
Operating Instructions, 04/2012, A5E02421799-03
Basic Panels