Paper Rolled In The Fuser; Paper Rolled On The Opc Drum - Ricoh G186 Service Manual

does not work properly): Perform EDC
Mode.
3. Pad-Friction is contaminated with
foreign matter (oil...)
4. The face of the paper is bent.

4.3.8 PAPER ROLLED IN THE FUSER

Description:
If contaminated at intervals of 57mm on the back of a paper.
Check and Cause
1. Contamination of the pressure roller or
heat roller (Background, Hot off set).
2. Check the claws of the fuser for
deformities.

4.3.9 PAPER ROLLED ON THE OPC DRUM

Description:
Paper is rolled up in the OPC.
Check and Cause
1. Paper is too thin.
2. The paper is curled.
SM
The Causes and Solutions of Bad Discharge
4. Use smooth paper.
Solution
1. After disassembling the fuser, clean
contamination between the heat roller
and the thermistor and remove the
contamination of the pressure roller.
2. If there is a heavy background, repair it
with the background troubleshooting
method.
3. Clean the surface of the heat roller with
IPA or water
4. Check the warp or separation of the
print claw and the holder plate claw,
and then manage it.
Solution
1. Use of normal paper is recommended.
2. How to remove rolled paper from the
4-19 G186