Installation Instructions - Assa Abloy Corbin Russwin Access 800 Series Installation Instructions Manual

1 Verify hand and bevel of door. Illustrations shown are as viewed from the outside
or secure side of opening.
Left Hand
Hinges Left.
Open Inward.
"LH"
Prep door according to supplied door marker.
2
Install latch bolt using
3
two # 8x3/4" screws.
Install strike plate using two #8-32x3/4" screws.
4
Screws
#8-32x3/4"

4) Installation Instructions

Left Hand
Reverse Bevel
Hinges Left.
Open Outward
"LHR"
7/8"
L C of 1-1/2 Dia
1-1/2
Conduit (optional) is available to
provide weather protection for
exterior applications. Install
Centerline of
conduit half with recessed panel
latch front
Not For Use On Fire Door visible
and strike
from outside of door.
Right Hand
Hinges Right.
Open Inward.
"RH"
Hole for ribbon cable 1/8"
Dia. holes (2) required
Fire Stop Plate required for
fire rated doors
Slot
Outside
of Door
Attach fire stop plate
using self tapping screws
#8-32x1/2" long for wood &
metal doors.
Latch bolt
door prep
Pre-drilled
and/or tapped
holes, 2 places
5
ASSA ABLOY
Right Hand
Reverse Bevel
Hinges Right.
Open Outward
"RHR"
Hole for
ribbon
cable
Outside
of Door
Lock body
hole
Non Fire Rated
Doors
ElectroLynx® is a registered trademark of ASSA ABLOY Inc.
Copyright © 2014 Corbin Russwin, Inc. All rights reserved.
Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
®