Assa Abloy Corbin Russwin Access 800 Series Installation Instructions Manual page 6

Installing chassis to door
5
Feed lock body wire harness through 2-1/8" diameter lock body hole and then install
lock body into door.
Inside of door
Ensure lock body wire harness is positioned in the vertical slot. Attach inside cassette
6
housing and secure with screws.
Connect the REX connector on I/S
cassette to connector on lock body
Making certain that both wires are in
harness slot
Install door position switch into hole on edge of door.
7
4) Installation Instructions
Harness Slot
Tighten latch
assembly screws
Inside of Door
Feed wires and
connector if metal
door
DPS connector wire should come out
between edge of cassette.
I/S Cassette
Housing
6
ASSA ABLOY
Collar is used only with metal doors.
Door Position Switch
ElectroLynx® is a registered trademark of ASSA ABLOY Inc.
Copyright © 2014 Corbin Russwin, Inc. All rights reserved.
Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
®