Assa Abloy Corbin Russwin Access 800 Series Installation Instructions Manual page 12

CL33800 WI1/IP1 Series Cylindrical Lock
A
Frame Harness Installation
Supplied by CI
Crimp Connector
Ceiling
24AWG
Stranded
Drain
Wire for
Earth
Ground in
15' Frame
Harness
Frame-Side
Harness
Assembly
(15' length)
Cable drain wire
concealed in shrink
tubing
Hinge-side harness connectors:
• 4-pin male molex connector
• 6-pin male molex connector with ground wire
Lock-side harness connectors:
• Ring terminal
• (2) 4-pin connectors
5) IP1 (PoE) Installation Wiring
Components and wire harness supplied by McKinney: Suggested installation.
Cut end / ceiling-side PoE harness:
B-Splice
RJ45-M
Do not confuse pair numbers with pin numbers. A pair number is
used for reference only (eg: 10Base-T Ethernet uses pairs 2 & 3). The
pin numbers indicate actual physical locations on the plug and jack.
Hinge side of PoE harness:
1. Feed cut end of harness into hole on hinge-side through single access
hole.
2. Push one of the connectors back through hole and feed into separate
access hole.
Each of the hinge-side harness connectors should end up threaded th-
rough a different access hole and matched to the same size pin connec-
tor from the door harness:
•
•
Molex-M
B
TIA/EIA-568B Standard Wiring
Pair Number
1 White/Blue
2 White/Orange
3 White/Green
4 White/Brown
4-pin male Molex connector.
6-pin male Molex connector with ground wire.
Notes:
• Connectors only go on one way. They cannot be plugged to
incorrect position.
• Do not force and do not offset connectors.
• Be sure they are completely seated ( ush).
4-pin M
B
6-pin M
Frame
12
ASSA ABLOY
Wire
White/Blue
Blue
White/Orange
Orange
White/Green
Green
White/Brown
Brown
4-pin F
6-pin F Drain Wire
PoE Hinge (Patent Pending)
ElectroLynx® is a registered trademark of ASSA ABLOY Inc.
Copyright © 2014 Corbin Russwin, Inc. All rights reserved.
Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
®
PIN
5
4
1
2
3
6
7
8