Assa Abloy Corbin Russwin Access 800 Series Installation Instructions Manual page 7

Hide thumbs Also See for Corbin Russwin Access 800 Series:

Installation of Outside Escutcheon

1A. For ﬁre rated doors feed ribbon cable connector and ground wire from outside escutcheon

through the ﬁre stop plate.

1B. For non-ﬁre rated door applications, optional gaskets may be used as a weather seal

between the escutcheon and the door surfaces. An optional conduit is also available for

further protection. Feed ribbon cable connector and ground through the conduit (if used).

2. Slide the outside escutcheon over the lock and hold the escutcheon to the door surface.

C A U T I O N

DOOR MUST REMAIN OPEN

DURING INSTALLATION.

USE DOOR STOP.

4) Installation Instructions

Gasket

(optional)

GASKET APPLICATION:

Peel off the adhesive protective paper

from gasket. Feed keypad ribbon cable

and ground wire through gasket

opening as shown and ﬁrmly press

gasket to escutcheon, aligning edge of

gasket with the edge of the escutcheon.

ASSA ABLOY

ElectroLynx® is a registered trademark of ASSA ABLOY Inc.

Reproduction in whole or in part without the express written

permission of Corbin Russwin, Inc. is prohibited.

Table of Contents