Assa Abloy Corbin Russwin Access 800 Series Installation Instructions Manual page 8

8
Installation of Inside Escutcheon and Electrical Connections
9
1. Remove black battery cover from the escutcheon with high security T20 Torx bit provided.
2. Connect ground wire to terminal, connect keypad ribbon cable to controller, connect lock
body harness to motor connector, connect DPS, and connect remote power if applicable.
3. Feed all excess wire through inside door hole and/into inside escutcheon cavity, being careful
not to pinch wires.
NOTE: Connectors go on only one way. Do not offset connectors and be sure they are
completely seated.
4. Insert 2 #10 x 24 screws through top and bottom of inside escutcheon (use painted screw on
top) and thread into outside escutcheon. Straighten escutcheons and tighten securely, being
careful to avoid pinching wires.
C A U T I O N
DOOR MUST REMAIN OPEN
DURING INSTALLATION.
USE DOOR STOP.
Locate (2) oval head screws and insert
through the escutcheon into the outside
escutcheon. Tighten firmly.
*Use screw with painted white
head in top hole. Failure to do this
will result in damage to
electronics.
# 10 x 24 Oval
Head Screw
# 10 x 24 Oval
Head Screw
4) Installation Instructions
Motor Connector
Lock Body Harness
Gasket
(optional)
Keypad Ribbon
Cable
Remote Power Connector
Ground Terminal
1
Remote Power
Ground Terminal
DPS
Remote Power
(if applicable)
Keypad Ribbon
®
Cable iCLASS
Cable
Ground Wire
Lock Body Harness
8
ASSA ABLOY
Inside of the Door
ElectroLynx® is a registered trademark of ASSA ABLOY Inc.
Copyright © 2014 Corbin Russwin, Inc. All rights reserved.
Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
®