Calling The Softune Workbench; Calling The Softune Workbench From The Dos Command Line - Fujitsu F2MC-8L Series Application Note

Hide thumbs Also See for F2MC-8L Series:

Table of Contents

3 Calling the Softune Workbench

In the following it is shown how to call the Softune Workbench (automatically starting the

debugger and loading the target .abs-file.

The Softune Workbench can be called from the command line using the following command

(assuming for this example the FR Softune Workbench V6 was installed to the directory

C:\Softune6 on the PC).

When the preparation steps in chapter 2 have been followed appropriately the Softune

Workbench will start and automatically load the last used Workspace (my_swb_project in

this example) and finally proceed with starting the debugger tool as selected in

my_swb_project.sup.

Application Notes related to Softune Workbench and/or Debugging/Emulation for further

reading:

mcu-an-391026-e-vxx-mb2198_install

mcu-an-391027-e-vxx-mb2198_getting_started

mcu-an-391028-e-vxx-mb2198_emulation

mcu-an-300028-e-vxx-mb91460_swb_monitor_debugger

mcu-an-391029-e-v11-swb_customize_build

MCU-AN-300097-E-V11

Softune Workbench Automatic Debugger Start

Chapter 3 Calling the Softune Workbench

C:\Softune\fs911s.exe

- 12 -

Table of Contents

F2mc-16lx series F2mc-fr series