Special (Reset) Function; Oil Reset Service; Electronic Parking Brake Reset - LAUNCH TECH X-431 PRO5 User Manual

LAUNCH

6 Special (Reset) Function

Except that the special functions can be performed from the diagnostic menus (See Chapter 5.2.3) of certain vehicle
model, this module provides an easy dial to quickly access the special functions.
The most commonly performed service functions contain:
 Oil Reset Service
 Electronic Parking Brake Reset
 Steering Angle Calibration
 ABS Bleeding
 TPMS (Tire Pressure Monitor System) Reset
 Gear Learning
 IMMO Service
 Injector Coding
 Battery Maintenance System
 Diesel Particulate Filter (DPF) Regeneration
 Electronic Throttle Position Reset
 Gearbox Matching
 AFS (Adaptive Front-lighting System) Reset
 Sunroof Initialization
 Suspension Calibration
There are two methods to reset service lamp: Manual reset or Auto reset. Auto reset follows the principle of sending
command from the tool to vehicle's ECU to do resetting. While using manual reset, users just follow the on-screen
instructions to select appropriate execution options, enter correct data or values, and perform necessary actions,
the system will guide you through the complete performance for various service operations.

6.1 Oil Reset Service

This function allows you to perform reset for the engine oil life system, which calculates an optimal oil life change
interval depending on the vehicle driving conditions and climate.
This function can be performed in the following cases:
1. If the service lamp is on, you must provide service for the car. After service, you need to reset the driving mileage
or driving time so that the service lamp turns off and the system enables the new service cycle.
2. After changing engine oil or electric appliances that monitor oil life, you need to reset the service lamp.

6.2 Electronic Parking Brake Reset

1. If the brake pad wears the brake pad sense line, the brake pad sense line sends a signal sense line to the
on-board computer to replace the brake pad. After replacing the brake pad, you must reset the brake pad.
Select "Reset"
Select the desired reset
item (e.g. oil lamp reset
etc.)
Follow the instructions
on the screen to operate
Select the service mode
(The available mode varies
from vehicle to vehicle)
Select the car brand
42
X-431 PRO5 User Manual