Connection Settings; Pairing Devices On Front Panel; Operation In A System With A Navigator - Extron electronics NAV 10E 401 D Setup Manual

Connection settings

View and change connection settings as follows:
On the home page, click
1.
(2) >
Networking
pane opens (see figure 8), showing protected views of the network
connection settings.
NOTE: Editing of connection settings is disabled when the
device is assigned to an Extron NAVigator System Manager.
To change the settings, click
2.
button changes to
Click in the desired field (2) and edit it as desired.
3.
Repeat step 3 as necessary for other values.
4.
Click .
5. Save

Pairing devices on front panel

Pair devices from the front panel as follows:
Remove and retain the six mounting screws securing the faceplate
1.
to the encoder (see
Use a Tweeker or other small screwdriver to press and hold the
2.
encoder
button on the front panel (see
ID
page 1) for approximately 3 seconds, until the ID LED blinks.
The encoder enters pairing mode, which allows decoders to
receive AV streams from encoders.
One at a time, use a Tweeker or other small screwdriver to press and
3.
hold the decoder front panel
to the encoder.
Repeat steps 2 and 3 for each decoder.
4.
Use a Tweeker or other small screwdriver to press and release the encoder front panel
5.
pairing mode.
Replace the faceplate with the six screws removed in step 1.
6.
Repeat steps 1 through 6 to pair decoders to other encoders.
7.
After all devices are connected, powered on, and paired, the system is fully operational.

Operation in a System with a NAVigator

The Extron NAVigator is a system manager that easily configures and controls the NAV System. The NAVigator supports a 16
endpoint system by default, but if a LinkLicense™ is installed, it can support up to 240 endpoints.
See the NAVigator User Guide, available at
(see figure
Settings
(3). The Network Connection
Network Connect
(see figure 8, 1). The
Edit
.
Save
figure 4 on page 4). Remove the faceplate.
figure
button for approximately 3 seconds, until the ID LED blinks. The decoder is now paired
ID
www.extron.com
7, on page 6) >
1
Edit
ID
1,
on
E
Figure 8.
for details.
2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2 2
1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1 1
Network Connection Pane
button. The encoder exits
ID
7