Led Indicators; Firmware Upgrades; Sis Commands; Using The Command And Response Table - Extron electronics HDP 101 4K User Manual

CONFIG
HDP 101 4K • User Guide (Continued) HDMI IN

LED Indicators

A
L
HDP 101 4K HDP P P P P
CONFIG
HDMI IN I I I N N N N N N
HDP 101 4K LED Indicators
Figure 4.

Firmware Upgrades

The HDP 101 4K firmware can be upgraded via Product Configuration Software (PCS) or the Extron Firmware Loader program
(available at www.extron.com).

SIS Commands

The HDP 101 4K can be configured with specific SIS commands via a USB connection. Use the Extron DataViewer utility or
a control system to send and receive SIS commands. SIS commands consist of one or more characters per field. No special
characters are required to begin or end a command sequence. When the HDP 101 4K recognizes a valid command, it executes
the command and sends a response to the host device. All responses from the receiver to the host end the character string with a
carriage return and a line feed (CR/LF =
When the HDP 101 4K is first switched on, it sends the message:
© Copyright 2018, Extron Electronics HDP 101 4K, Vx.xx, 60-xxxx‑xx]
• Vx.xx is the firmware version number.
• 60-xxxx‑xx is the part number of the device.

Error Responses

When the HDP 101 4K receives a valid SIS command, it executes the command and sends a response to the host device. If the
HDP 101 4K is unable to execute the command because the command is invalid or contains invalid parameters, it returns the
following error responses to the host:
–
• E10 Invalid command
–
• E13 Invalid parameter

Using the Command and Response Table

The Command and Response Table for SIS Commands
• Valid ASCII command codes
• The device response to the host
• A description of the command function, or the results of executing the command
The ASCII to hexadecimal conversion table below is for use with the command and response table:
ASCII to Hex Conversion Table
Space
0.1A MAX
SIG
DP OUT
B
POWER
12V
0.1A MAX
SIG
DP OUT T
]
). A string is one or more characters.
•
Power and signal LED (front) — Lights amber to indicate power,
A
and lights green to indicate HDMI signal presence.
Output signal LED (rear) — Lights green to indicate signal
B
presence on the DisplayPort output.
starting on page 6 lists the following:
4