Feig Electronic OBID i-scan ID ISC PRHD102 Manual page 73

®
OBID i-scan
OUT-S:
OUT-S (Output State) defines the status of the output during the time defined in OUT-
TIME and provides the possibility to allocate its own flashing-frequency to each output.
Bit:
Function:
OUTx-mode:
b00
b01
b10
b11
OUTx-frq:
b11
b10
b01
b00
OUT-TIME:
By the values defined by "OUT-TIME", the outputs can be activated temporary limited or
unlimited.
An exception are the time values 0 and 65535 (0xFFFF) (see following table).
0x0001
...
0xFFFE
0xFFFF
Notes:
•
In order to reset a continuously active time, OUT-TIME = 1 has to be sent to
the Reader, which effects a change to the idle status after 100 ms.
•
The continuous activation is being set back after a reset or a power failure.
FEIG ELECTRONIC GmbH
7 6 5
0 0 0
UNCHANGED
ON
OFF
FLASH
1 Hz
2 Hz
4 Hz
8 Hz
1 x 100ms
...
65534 x 100ms -> 1:49:13 h
continuously active
Page 73 of 125
Manual
4 3 2
0 OUTx-frq
OUT-TIME has no effect on the status of the output
output for OUT-TIME = active
output for OUT-TIME = inactive
output for OUT-TIME = with OSF alternating
-> 100ms
ID ISC.PRHD102
1 0

OUTx-mode
H71101-2e-ID-B.doc