Feig Electronic OBID i-scan ID ISC PRHD102 Manual page 20

®
OBID i-scan
Structure of configuration parameter description.
Byte 0
contents RAM-eff.
not marked
Changing of this parame-
ter becomes immediately
effective after writing /
saving this configuration
block to RAM
Labeling of configuration parameters.
Each configuration parameter has a short name and a structured long name, like:
SHORT-NAME: (Long-Name)
Example 1:
READER-MODE: (OperatingMode.Mode)
Example 2:
BAUD: (HostInterface.Serial.Baudrate)
The short name is used inside the hex bar because of limited space. The structured long name is
the proper parameter name and is placed in brackets behind the short name, when the parameter
is described in detail.
The reason for the launch of structured long names is to unify all parameter names for all OBID i-
scan Readers. Structured long names are built with one or more namespaces divided by a point
and an attached parameter name.
The structured long names are used as from now in ISOStart 8.0 and beginning with version 3.0.0
of Software Development Kits (SDK).
A summary of the parameter are shown in chapter:
FEIG ELECTRONIC GmbH
1 2
EEPROM- 00
eff.
res
gray marked
Changing of this parame-
ter only becomes effective
after writing / saving this
configuration
EEPROM and a Reader
reset
Page 20 of 125
Manual
......n
.....
marked with "00"
these bits or bytes are reserved for
future extensions or for internal
testing
functions. These bits or bytes and
also any not described bits and
bytes must not be changed, as
this may cause faulty operation of
the Reader.
block to
ANNEX F: Labeling of configuration parameter
ID ISC.PRHD102
and manufacturing-
H71101-2e-ID-B.doc