Feig Electronic OBID i-scan ID ISC PRHD102 Manual page 34

®
OBID i-scan
4.7. CFG10: Trigger
The configuration blocks contains parameters for the trigger configuration.
Byte 0
Contents TRIGGER-
MODE
Default
Byte 7
Contents 0x00
Default
TRIGGER-MODE (OperatingMode.ScanMode.Trigger.Mode)
defines the mode of the scanner.
Bit:
Function
mode:
b00:
b01:
FEIG ELECTRONIC GmbH
1 2
0x00 0x00
8 9
0x00 0x00
7 6 5
0 0 0
Single Read: (active for read duration – stops after good read)
When all Transponders in detection range has been decoded, the
Reader will stop the scan. The Reader must be triggered again to read
other Transponders.
Continuous Read:
The Reader will read as much Transponders as it can decode regard-
less whether it is the same or not. This mode is mainly used for demon-
stration and diagnostic.
Page 34 of 125
Manual
3 4
0x00 0x00
10 11
0x00 0x00
4 3 2
0 0 mode
ID ISC.PRHD102
5 6
0x00 0x00
12 13
0x00 0x00
1 0
0
H71101-2e-ID-B.doc