®
OBID i-scan
Notes:
•
Scan-Mode (reading of serial number and data):
if the serial number was read OK and the data not, no data set will be transferred, but the assigned LED will
be active.
•
LED green and LED red are blinking alternately if a read error of the EEPROM occurred.
After power-up or a
seconds
•
4.3.1. Dedicated Input / Output Functions
LED
1
2
3
5
FEIG ELECTRONIC GmbH
6.3. [0x63] RF Controller Reset
Color
1.
The Reader is initializing after power up or a
Controller Reset
green
2.
1 second blink.
3.
Alternately blink with red LED after an EEPROM error.
1.
The Reader is initializing after power up or a
Controller Reset
blue
2.
The RF interface has an faultless communication with a Trans-
ponder.
yellow
res.
1.
The Reader is initializing after power up or a
Controller Reset
red
2.
Signalize a low battery state
Page 29 of 125
Manual
command all LEDs are blinking for 2
Dedicated Function
command.
command.
command.
ID ISC.PRHD102
6.3. [0x63] RF
6.3. [0x63] RF
6.3. [0x63] RF
H71101-2e-ID-B.doc