Feig Electronic OBID i-scan ID ISC PRHD102 Manual page 22

®
OBID i-scan
To change the READER-ID you must write to the CFG0 immediately after the Login to the Reader
with the command
Notes:
•
A READER-ID = 0x00000000 disables the password function.
•
A read with the command
'0x00000000'.
•
A changed password becomes valid after a Reader reset.
•
The command
ter if all configuration blocks are used.
•
The command
access.
Config Protection
By means of Config Protection, the access to the configuration parameters stored within the Read-
er is protected by a 32-bit password, the "READER-ID". This means that only after a "Login" with a
valid READER-ID with the command
the EEPROM of the Reader may be read and changed in the EEPROM of the Reader.
FEIG ELECTRONIC GmbH
Manual
6.10. [0xA0] Reader-Login
5.1. [0x80] Read Configuration
5.3. [0x83] Set Default Configuration
6.10. [0xA0] Reader-Login
6.10. [0xA0] Reader-Login
Page 22 of 125
will always get
don't change the CFG0 regis-
is used to enable configuration data
can configuration parameters in
ID ISC.PRHD102
H71101-2e-ID-B.doc