Removing And Installing Clutch Pedal (Octavia Ili) - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Octavia III 2013 ➤ , Octavia III ...
Gearbox 0AF - Edition 09.2013
– Attach support -2- to the actuator rod -1- of the master cylinder.
– Press support into the clutch pedal until it audibly clicks into
place.
– Insert retractor spring spring from above into the bearing
bracket and while doing so hold the spring end in the fitting
position using the release tool -T10178- .
– Insert bearing bolt of clutch pedal into the step bearing of the
retractor spring.
– Press on clutch pedal slightly, slide through screw and tighten
self-locking nut.
– Screw on crash strut -1- in front of the clutch pedal -2-.
– Install lower part of the dash panel insert on the driver's side
⇒ Body Work; Rep. gr. 70 .
Tightening torques
Component
Crash strut
Clutch pedal to bracket
1)
Replace self-locking nut.
1.10 Removing and installing clutch pedal
(Octavia IlI)
Removing
– Push the driver seat as far as possible towards the rear.
26
Rep. gr.30 - Clutch
1)
Tightening torque
9 Nm
⇒ page 15