Removing And Installing Cables For Clutch Control (Octavia Iii) - Skoda Octavia II 2004 Workshop Manual

– Place a non-fluffing cloth under the slave cylinder.
– Unlock the clip -A- with a screwdriver and disconnect the tube-
hose line -B- from the connection.
– Pull tube-hose line -B- out of the slave cylinder and close
openings.
– Unscrew screws -arrows- and remove slave cylinder.
Caution
There is a risk of contamination through escaping brake fluid.
♦ If the tube-hose line is disconnected from the connection,
do no longer depress the clutch pedal.
Install
The installation is performed in the reverse order, pay attention
to the following points:
Note
Grease all bearing points and contact surfaces with grease.
♦
Assignment grease ⇒ Electronic Catalogue of Original Parts .
♦
– Fit slave cylinder -A- and tighten screws -arrows-.
– Connect tube-hose line -B-
– Bleed the clutch control
– Insert battery tray and connect battery ⇒ Electrical system;
Rep. gr. 27 .
Tightening torque:
♦ Slave cylinder to gearbox
1.23 Removing and installing cables for
clutch control (Octavia III)
Special tools and workshop equipment required
♦ Hose clamp - MP7-602 (3094)-
Removing
– Remove the complete air filter housing if the cables for the
clutch control are not accessible ⇒ Engine; Rep. gr. 24 .
– Remove battery and battery tray ⇒ Electrical System; Rep.
gr. 27 .
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Octavia III 2013 ➤ , Octavia III ...
⇒ page 42 .
⇒ page 50 .
⇒ page 41 .
Gearbox 0AF - Edition 09.2013
1. Repairing clutch control
47