Checking The Master And Slave Cylinder (Octavia Iii); Removing And Installing Slave Cylinder (Octavia Ii) - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Octavia III 2013 ➤ , Octavia III ...
Gearbox 0AF - Edition 09.2013
1.20 Checking the master and slave cylinder
(Octavia III)
Before the master cylinder must be replaced due to a fault, first
of all carry out the test in the
hicle diagnostic tester.
1.21 Removing and installing slave cylinder
(Octavia II)
Special tools and workshop equipment required
♦ Hose clamps - MP7-602 (3094)-
♦ Grease - G 000 100-
Note
If the slave cylinder must be replaced due to a predetermined
♦
fault, first of all check the hydraulic clutch control
If the slave cylinder with the connected tube-hose line is re‐
♦
moved from the gearbox, do no longer depress the clutch
pedal. Otherwise, the piston can be pressed out of the slave
cylinder and thus be destroyed.
When performing the following work, make sure no brake fluid
♦
comes into contact with the gearbox. If this is the case, these
points must be cleaned thoroughly.
1.21.1 Removing
Note
If the battery earth strap is disconnected and connected, carry out
additional operations ⇒ Electrical System; Rep. gr. 27 .
– Disconnect the battery-earth strap with the ignition off ⇒ Elec‐
trical System; Rep. gr. 27 .
– Remove air filter ⇒ Engine; Rep. gr. 24 .
– Remove battery and battery tray ⇒ Electrical System; Rep.
gr. 27 .
44
Rep. gr.30 - Clutch
Targeted fault finding
⇒ page 43
⇒ Ve‐
.