Bleeding The Clutch Control (Octavia Iii) - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Octavia III 2013 ➤ , Octavia III ...
Gearbox 0AF - Edition 09.2013
– Fit the bleeder hose onto the vent valve -arrow-.
– Activate system with a pressure of 0.2 MPa.
– Open vent valve.
– Allow approx. 100 cm
– Close vent valve.
– Activate pedal forcefully from stop to stop between 10 and 15
times.
– Activate system with a pressure of 0.2 MPa.
– Open vent valve.
– Allow approx. 50 cm 3
– Close vent valve.
– After completing the bleeding procedure activate the clutch
pedal repeatedly.
– If necessary, bleed the clutch control once again
– Install air filter ⇒ Engine; Rep. gr. 24 .
1.25

Bleeding the clutch control (Octavia III)

Special tools and workshop equipment required
♦ Brake filling and bleeding device , e.g. -VAS 5234- or -ROM‐
ESS-
Note
♦ The system must be bled after performing work on the hy‐
draulic clutch control.
When performing the following work, make sure no brake fluid
♦
comes into contact with the gearbox.
A pre-filling of the system is not necessary!
♦
Before bleeding, fill brake fluid reservoir up to "Max" marking
♦
with brake fluid.
Clutch pedal in home position, not operated.
♦
Specification of brake fluid ⇒ Electronic catalogue of original
♦
parts .
– If the vent valve is not accessible, remove the complete air
filter housing (-arrow- in the illustration below) ⇒ Engine; Rep.
gr. 24 .
50
Rep. gr.30 - Clutch
3
of brake fluid to flow out.
more brake fluid to flow out.
⇒ page 49 .