– Insert the components together into the gearbox housing, by
passing the guide bolt - T10079- through the fixing holes of the
gearshift mechanism in the gearbox housing.
– Unscrew guide bolt - T10079- .
– Check before pressing on the bearing support:
♦ To click in the shift forks into the sliding sleeves correctly.
♦ Dimension -a- of the output shaft serration.
Note
The drive shafts of the individual gearboxes have different
♦
lengths due to the different heights of the serration, dimension
-a-.
In order to press in the drive shaft and the output shaft at the
♦
same time, a 3 mm thick washer - T10083/1- must be posi‐
tioned onto the drive shaft, if necessary.
Therefore, the dimension -a- of the output shaft serration must
♦
be measured.
•
Dimension -a- = 30.6 mm
– Fit the washer - T10083/1- onto the drive shaft and carefully
press in the bearing support together with the drive shaft and
the output shaft up to the stop.
Octavia II 2004 ➤ , Octavia II 2010 ➤ , Octavia III 2013 ➤ , Octavia III ...
Gearbox 0AF - Edition 09.2013
4. Disassembling and assembling the gearbox
137