Summary Of Components - Control Cables Up To 10.2006 (Octavia Ii) - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Octavia III 2013 ➤ , Octavia III ...
Gearbox 0AF - Edition 09.2013
• The shift lever guide must protrude out of the shift housing as
far as the stop.
– Lift the upper leg -A- of the pressure spring over the stud of
the selector angle plate.
• Use a new bearing shell -B-.
– Grease the bearing shell and the bearing ball of the shift lever
guide with grease - G 000 450 02- .
– Press the bearing shell up to stop onto the bearing ball of the
shift lever guide.
– Remove shift housing from the insert base - T10083- .
– Press the bearing shell into the shift housing -arrows-.
• All catch pegs must click audibly.
– Insert the lower leg -C- of the pressure spring into the guide.
– Lift the upper leg -A- of the pressure spring over the stud of
the selector angle plate into the guide.
Note
Install the shift lever if it was removed.
– Attach shift cable and selector cable to shift housing with cir‐
clips -2 and 3-.
– Press shift cable and selector cable onto shift lever and se‐
lector lever into shift housing (lock washers -1 and 4- are no
longer available).
– Install gasket and attach cover for shift mechanism by bending
up the tabs -arrows-.
– Installing shift mechanism
– Setting the shift mechanism
1.10

Summary of components - Control cables up to 10.2006 (Octavia II)

Note
Grease bearing and friction surfaces with grease - G 000 450 02- .
82
Rep. gr.34 - Controls, housing
⇒ page 94 .
⇒ page 102 .