Removing And Installing Bearing Bracket For Clutch Pedal (Octavia Iii) - Skoda Octavia II 2004 Workshop Manual

Octavia II 2004 ➤ , Octavia II 2010 ➤ , Octavia III 2013 ➤ , Octavia III ...
Gearbox 0AF - Edition 09.2013
– Screw on crash strut -1- in front of the clutch pedal -2-.
– Install lower part of the dash panel insert on the driver's side
⇒ Body Work; Rep. gr. 70 .
– Press in tube-hose line -1- with gasket ring -2- onto the con‐
nection of the master cylinder -4-, until the locking clip -3- is
heard to click into position.
– For testing pull on the tube-hose line.
– Bleed the clutch control
– Install the battery tray and battery ⇒ Electrical System; Rep.
gr. 27 .
– Install air filter ⇒ Engine; Rep. gr. 24 .
Note
After the battery earth strap is disconnected and connected, carry
out additional operations ⇒ Electrical System; Rep. gr. 27 .
– Connect earth strap of battery ⇒ Electrical System; Rep. gr.
27 .
Tightening torques
Component
Crash strut
Mounting bracket on the body
1)
Replace self-locking nut.
1.12 Removing and installing bearing bracket
for clutch pedal (Octavia III)
Special tools and workshop equipment required
♦ Hose clamp - MP7-602 (3094)-
♦ Closing tool - T10249-
Removing
– Push the driver seat as far as possible towards the rear.
– Push steering wheel as far as possible towards the top, while
doing so use the entire adjustment range of the steering col‐
umn.
30
Rep. gr.30 - Clutch
⇒ page 49 .
1)
Tightening torque
9 Nm
⇒ page 15