Maintenance Work; Checking The Condition Of The Sieve And Removing Dirt From It - SINTERIT POWDER HANDLING STATION User Manual

10. Maintenance work

A. CHECKING THE CONDITION OF THE SIEVE AND REMOVING DIRT FROM IT
1. Start working only with the vacuum cleaner switched off.
2. Open the door of the Sifting module
walls falls on the Vibrating Sieve
3. Remove the sieve locking pin and unfasten the clamping ring
Image. 43. Tapping the flexible tube
to remove from the powder.
4. Lift and attach the sieve Flexible tube with the flange
clamping ring on the flange so that it does not fall on the sieve
5. Release the drawer locks of the sieve
31 | POWDER HANDLING STATION Manual
WARNING!
Before starting any repair or maintenance work, please read the safety information in section 2.F.
„Safety during repair and maintenance".
ATTENTION!
•
When working with powder, wear individual protection (Protective Gloves,
antistatic shoes, face protection: Protective Glasses, Protective Dust Mask).
•
When working with a PHS device, hearing protection is required.
•
To prevent dust from being inhaled at all times, always wear respiratory
protection (dust mask).
11 and tapping the flexible tube of the sieve
(image 43).
30
32 and Metal container
(image 44)
29
Image. 44. Remove the pin and unfasten
the clamping ring.
28 to the magnetic holders of the Sieve flange
30 (image 45).
38 .
28 so that the powder from the
27 . Put a