SINTERIT POWDER HANDLING STATION User Manual page 28

24. If the whole powder has been sifted (you cannot see it in the Powder Chamber and on the Sieve), you can turn off
the Sifting module
• If the powder is still in the Powder Feeding Screw
the Powder Chamber by the Powder Feeding Screw
• If the time has ended and the powder is still in the Powder Feeding Screw
pressing the SIFTING ON/OFF button.
• Opening the Sifting module door switches off the mechanism
the door does not automatically turn on the Sifting module again (the SIFTING ON/OFF button must be turned on
again if necessary).
25. For checking whether the whole powder has been sifted:
25.a. Open the door of the Sifting module
walls falls on the Vibrating Sieve
25.b. Remove the sieve locking pin and unfasten the clamping ring
25.c. Lift and attach the Flexible tube with the flange
ring on the flange so that it does not fall on the sieve
25.d. Check whether there is still any powder in the sieve (image 34d).
25.e. If the powder is still in the sieve
lock it with a locking pin and close the door. Switch on the sifting with the SIFTING ON/OFF button.
a. Tapping the sieve flexible tube to remove from the powder.
c. Attach the flange of the sieve to the magnetic holders.
27 | POWDER HANDLING STATION Manual
11 faster by pressing the SIFTING ON/OFF button
11 and tapping the flexible tube of the sieve
30 (image 34a).
, lower the Flexible tube with the sieve flange
30
14 on the Control panel.
23 , you should turn on the vacuum cleaner and wait for emptying
23 and then switch off the vacuum cleaner.
23
23 , and the Sifting module
(image 34b).
29
28 to the magnetic holders of the sieve flange
30 (image 34c).
b. Remove the pin and unfasten the clamping ring.
d. Check if there is powder in the sieve.
, you can turn the sifting on again by
11 stops working. Closing
28 so that the powder from the
27 . Put a clamping
, put on the clamping ring
28
,
29