SINTERIT POWDER HANDLING STATION User Manual page 27

17. Powder located in Overflow Bin from the printer should be poured on the Powder Chamber grid
ATTENTION!
Do not pour the powder from Overflow Bin into the Fine Dusting Powder Chamber
machine is in operation, this chamber must always have access to air for the entire system to
function properly. It is allowed to clean the prints above it.
18. Collect all remaining powder from the Worktop with a spatula or Powder Wiper and transfer it to the Powder Chamber
grid . Make sure that the powder is not on the grid of the Fine Dust Chamber
1
19. To remove the remaining powder from the printer's
Print Chamber, use a Suction hose
19.a. Remove the Suction Handle from the socket
The Powder Feeding Screw
and the LED above HANDLE
panel should light up.
19.b. Select the nozzle for the type of task (image 30).
We recommend a PVC Brush
Printing Chamber. Do not use the Suction hose
without the nozzle attached! - This may cause
damage/scratches on the cleaned surfaces
H General purpose nozzle,
•
Powder suction nozzle,
I
•
J Gap nozzle,
•
K PVC brush.
•
20. Holding the Suction hose above the surface of the powder, remove it from the Print Chamber and the housing of the
printer (image 31).
21. The Suction hose can also collect all remaining powder from the PHS Worktop if any (image 32).
Image 31. Clean the Print Chamber of the printer
from the remaining powder.
22. When the cleaning is finished, disconnect and put the nozzle in Toolboard also insert the Suction handle
socket . After this operation, the Powder Feeding Screw
4
chamber will be transported to the Sifting module
23. The Sifting module 11
detected in the system. When the vacuum cleaner is
switched off by the user, the Sifting module
the Sifting module timer
for about 20 minutes (LEDs show the remaining time
- image 33).
IMPORTANT!
Turning off the vacuum cleaner will stop
the Powder Feeding Screw
still powder in the chamber, it will not be
sent to the Sifting module
inactive Powder Feeding Screw.
3 .
23 should be stopped
16 on the Control
K to clean the
3
11
will work when a vacuum is
11 and
15 will continue to operate
23 . If there is
11 due to the
16 .
H I
Image 30. Insert a suitable nozzle
into the Suction Handle according to the task.
Image 32. Clean the PHS Worktop
from any remaining powder.
will be restarted and the powder that has been in the
23
.
SUCTION
PHS
VACUUM
HANDLE
ON/OFF
SIFTING
ON/OFF
TIMER
SUCTION
PHS
VACUUM
HANDLE
ON/OFF
SIFTING
ON/OFF
TIMER
SUCTION
PHS
VACUUM
HANDLE
ON/OFF
SIFTING
ON/OFF
TIMER
Image 33. The LEDs on the Control panel show the remaining
time of powder sifting after switching off the vacuum cleaner.
1 .
2 ! When the
.
2
J K
3
POWER
DEPOWDERING
ZONE
LIGHT
ON/OFF
POWER
DEPOWDERING
ZONE
LIGHT
ON/OFF
POWER
DEPOWDERING
ZONE
LIGHT
ON/OFF
POWDER HANDLING STATION Manual | 26
into the
TURN ON
VACUUM
FIRST
TURN ON
VACUUM
FIRST
TURN ON
VACUUM
FIRST