Heating-Panel Assembly - Dräger Babytherm 8000 Repair Instructions

Danger:
The gel mattress 2M 20 827 may only be used in the Babytherm 8000 in
conjunction with the resting-surface heater!
The gel mattress 2M 20 827 is not to be used in the Babytherm 4200 and in
other heated cots with a heating-panel temperature in excess of 40 °C ⇒
danger of burns!
Keep sharp objects away from the gel mattress ⇒ danger of damage!
3.2

Heating-panel assembly

The heating panel consists of the following components:
- Backing plate
- All-round seal for backing plate
- Foil heating 24V/120W bonded on for type BF
- Twin temperature sensor
The sensors are fitted with thermal
conduction paste at the backing-plate
contact surfaces.
The heating panel is secured in position in the cot from underneath with four bolts.
The heating panels for types B and BF have different order numbers.
The following heating-panel parts differ:
Heating panel 2M 20 877 for type B Heating panel 2M 21 510 for type BF
Double temp. sensor 2M 20 859 with
shield connected to sensors.
Identification: No yellow and blue
shrink-down tubing at sensors.
Sensor cannot be converted to type
BF.
Foil heating 2M 20 876 with 3-pin
connector:
- 2 x heating
- Protective conductor
6132.200 Babytherm 8000
Double temp. sensor 2M 20 859 with
insulated shield on sensor end,
distinguished by sensors with blue and
yellow shrink-down tubing. This sensor
can also be used in type B. Alteration
has already been made on some units
of type B.
Foil heating 2M 21 509 with 2-pin
connector:
- 2 x heating
Repair Instructions
2M 20 878
2M 20 882
2M 21 509
2M 20 859
04.01 Page 16 of 115