Table of Contents
Advertisement
Heating panel:
Type B
Heating panel 2M 20 877
Distinguishing feature:
- 3-pin connecting cable for
heating with protective conductor
Double temp. sensor 2M 20 859 with
shield connected to sensors.
Identification: No yellow and blue
shrink-down tubing at sensors.
Sensor cannot be converted to type
BF.
Foil heating 2M 20 876 with 3-pin
connector:
- 2 x heating
- Protective conductor
Important:
As regards the ordering of spares, only parts for type BF will be available in future.
In the event of repair, these parts can be converted to type B; refer to Section 9.3.4
or to the appropriate component sections in "3. Heating panel with sensors" and
"4. Mattress heating electronics".
9.4
Additional height adjustment extra high
On request, the Babytherm 8000 OC (Resuscitation/Open Care Unit), i.e. devices
equipped with the large trolley 2M 21 036, can be supplied with an electrical height
adjustment which is 64mm (= 2.5 inch) higher than the normal one. This extra high
height adjustment must not be used on the Heated Cot Babytherm 8000 WB with
the short trolley. For further details, refer to Chapters 1.1.2 und 1.2.
9.5
Castors of non-height-adjustable units
Units which are not equipped with an electric height-adjustment facility
manufactured in 1995 (ARJx-xxxx) may occasionally be provided with castors
secured by an additional stud screw M6 for reason of tolerance, see chapter
1.1.1.1 "Removal and installation of castors".
6132.200
Babytherm 8000
Type BF
Heating panel 2M 21 510
Distinguishing feature:
- 2-pin connecting cable for
heating with no protective conductor
Double temp. sensor 2M 20 859 with
insulated shield on sensor end,
distinguished by sensors with blue
and yellow shrink-down tubing. This
sensor can also be used in type B.
Some type B units already feature this
modification.
Foil heating 2M 21 509 with 2-pin
connector:
- 2 x heating
Repair Instructions
(02.95)
(03.95)
04.01
Page 115 of 115
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
