Dräger Babytherm 8000 Repair Instructions page 80

A B C
D
E
The heating can be switched on only in this mode for max. 60 s with the "check"
key. This causes the heating to be clocked (1 s on and 0.5 s off).
Heating test:
- Switch on safety relay in mode b.
- Switch on heating in mode C:
Alternating feedback E = 1 and 0 (in mode C)
Mode number can be switched with the keys "positive temp." or "negative temp.".
6.3.d Mode d Position of mains switch
Readout of position of mains-switch auxiliary contacts for warm/cold-start
recognition.
F
A B C
D
6132.200 Babytherm 8000
= HEA as flag for heater (heating)
= Request, switching status, heating
0 =
1 =
= Heating feedback
0 =
1 =
Back
A B C
D E F
37°C
35°C
= Mode number d flashing
= P F S as flag for power fail switch
= Position of mains-switch auxiliary contacts
Repair Instructions
Heating off
Heating on
Heating off detected
Heating on detected
Horn
Check
off
04.01 Page 80 of 115