Mattress Heating Software; Software Versions; Testing After Replacement - Dräger Babytherm 8000 Repair Instructions

5.

Mattress heating software

5.1

Software versions

The program is stored in an EPROM on the controller PCB.
Position in electronics system after opening electronics assembly:
The following software is envisaged:
- Software 1.00 / 1.01 mattress heating
- Software 1.02 mattress heating
- Software 1.04 mattress heating
5.2

Testing after replacement

See 4.2, however not including test with Babytherm 8000 test plug.
6132.200 Babytherm 8000
Connection protective
ground PCB Power + PCB Controller
V2 V11
Connection heating
PCB Power
R22
Gold Cap
Relay
Fuses
Test points
F2 F1
PCB Controller
Connection
EPROM
Sensors
4 Service-LEDs
Keyboard
Repair Instructions
Transformer
Horn
PCB Display
04.01
Mains input with fuses
Switch
not allowed
no longer available
2M 22 467
Page 68 of 115