Angelo Po 0G1CP1EC Use And Installation Manual page 27

RESETTING THE APPLIANCE
If the safety thermostat is tripped, the appliance has
to be restored to the initial working conditions as fol-
lows.
1 - Allow the water to cool by 30-40°C
2 - Open the hatch (A).
3 - Press the button (B) of the safety thermostat to
restore the electricity supply.
4 - Close the door (A) when the operation is com-
plete.
LENGTHY DOWNTIMES OF APPLIANCE
If the appliance is to be out of use for a lengthy pe-
riod, proceed as follows.
1 - Cut off the mains electricity supply using the ap-
pliance's master switch.
2 - Clean the appliance and the surrounding areas
thoroughly.
USEFUL ADVICE FOR USE
To ensure correct use of the appliance, the following
rules should be adopted.
– Use only the accessories recommended by the
constructor.
– Immerse the baskets in the boiling water very
slowly to avoid the formation of foam.
– To drain the baskets, suspend them on the hang-
er provided.
– Before filling the well, check that the drain tap (C)
is turned off.
– Check that the water level never drops below the
minimum level marked (B).
– Fill the baskets with the right quantity of pasta tak-
ing into account the type of pasta and the expect-
ed increase in volume during cooking.
– Always wait until the water is boiling before im-
mersing the baskets.
– Adjust the water flow so that the water is main-
tained at boiling temperature and continuously re-
newed to remove the starch.
B
B
3 - Spread a film of edible oil over the stain-
less steel surfaces.
4 - Carry out all the servicing procedures.
5 - Leave the appliance uncovered and the
cooking chambers open.
C
- 9 -
A
0G1CP1EC
IDM-39613600300.tif
A
0G1CP1E
IDM-39611700900.tif
B
IDM-39603600800.tif
IT
GB
DE
FR
ES
English