Table of Contents
Advertisement
JaNets JT Simple Instruction Manual for the setup and change of the line
The machine information setting dialog is displayed to allow you to enter the items
listed below.
⑤ Machine name
⑥ Machine number
⑦ Shift
⑧ Count condition
⑨ Number of counts
of times of thread
trimming
⑩ Final process
setting
After you have completed input, confirm the input data with the Save button ...⑪.
* As many as 20 half-width characters or 10 full-width characters can
be entered.
* It is not allowed to duplicate the machine name in the System.
* The machine number is automatically assigned by the System and
cannot be edited.
* The line shift information has already been entered and cannot be edited.
Conditions to be met to count the quantity of output are set.
BUTTON-JU: When the JUKI sewing machine button is pressed
Thread trimmer: When the thread is trimmed
Pattern End:
When the sewing-pattern sewing operation is completed
Cycle End:
When the cycle-pattern sewing operation is completed
BUTTON-NJ: When the button is pressed during the process carried
out by any machine other than the JUKI sewing machine
* This number can be entered in the case "Thread trimmer" is selected
in the setting item ⑧.
Put a checkmark to this setting item for the final process of the line.
* The total number displayed on the sewing counter in the final process
becomes the quantity of output of the line. Be sure to put a checkmark
at least to one unit of sewing machine.
Table 6-1
⑤
ｖ
⑧
Caution)
If the procedure described in II-5-1. Adding a line for
adding a line has not been completed, the message
shown at the left is displayed to disable registration of
the machine.
24 / 30
⑥
⑨
⑩
⑦
⑪
ｖ
Advertisement
Table of Contents
