Editing The Shift - JUKI JaNets JT Simple Instruction Manual

JaNets JT Simple Instruction Manual for the setup and change of the line

4-2. Editing the shift

Select the Basic configuration > Shift ... ① and press the Edit button ...②.
The shift name input dialog is displayed. Edit the Shift number ... ③, Finishing time
... ④, Work break time ... ⑤ and Shift reset time setting (min) ... ⑥.
* As many as 10 half-width characters can be entered as a shift name. (Full-width
characters cannot be entered.)
* The work break time will be disabled unless a checkmark is put to the work
break time checkbox.
* The work break time must be set within the working hours. If the work break
time falls out of the working hours, it will be cleared when the OK button ... ⑦
is pressed.
* The Shift reset time setting (min) ... ⑥ is the setting that determines the time (in
terms of minutes ahead of the starting time) at which the data on the shift such as
the target quantity of output, operation rate and progress chart are reset.
After you have entered the data on the shift, press the OK button ... ⑦ to confirm
the editing you have made.
①
③
④
⑥
15 / 30
②
⑤
⑦