System Setup; Configuration Data Relationship Diagram - JUKI JaNets JT Simple Instruction Manual

JaNets JT Simple Instruction Manual for the setup and change of the line
II. System setup
This section describes the setting items that are necessary to view various charts
such as the operation rate and quantity of output on the report center.

1. Configuration data relationship diagram

①
[ Configuration data relationship diagram ]
The relationship among the data that must be set
is displayed, as shown below, using the Basic
configuration ... ○ 1 of the report center.
* Floors and lines are placed under the factory.
Shifts and machines are placed under the lines
and registered with them. As many as 10 factories
can be registered. Shifts are retained as
separately-configured data.
7 / 30