Atto Fibrebridge 2400C; Board Dimensions; Cooling And Airflow; Power - ATTO Technology FibreBridge 2370E Installation And Operation Manual

The ATTO FibreBridge 2400C is a high performance bridge adding 4-Gigabit Fibre Channel connectivity to
legacy SCSI storage devices.
The FibreBridge 2400C is available in an industry-
standard 4U cPCI card for easy integration into storage
devices. Default values are appropriate for most
applications. Refer to Configuring the FibreBridge
on page 15 for more information.

Board dimensions

6.1939 inches
Width:
6.299 inches
Length:
Height of tallest component:

Cooling and airflow

Operating temperature: 0-40 °C
Humidity: 10-90% non-condensing

Power

NU 5V GND 5V 5V GND
The FibreBridge
1
board may be
powered from the
cPCI backplane connector or a 6-pin connector.
5.0V
Input voltage:
30 Watts
Power draw:
Battery-backed event log SRAM & Real-Time-
A rechargeable Lithium ion battery cell holds
Clock:
the memory in a 512KB SRAM for up to 30 days.
WARNING
WARNING
Risk of explosion if the battery is removed
and/or replaced by an incorrect type.
Dispose of used batteries in accordance
with your local environmental regulations.
Explosionsgefahr, wenn die Batterie falsch
entfernt und/oder ersetzt wird. Entsorgen
Sie benutzte Batterien in Übereinstimmung
mit Ihren lokalen
Umweltschutzbestimmungen.
If the FibreBridge becomes disconnected from power,
recharging begins automatically when power is
restored to the system. The battery is fully charged
after 24 hours of continuous power application.
11
ATTO Technology Inc. FibreBridge Installation and Operation Manual

1.5 ATTO FibreBridge 2400C

.545 inches
6-pin connection pinouts
2 3 4 5 6

Fibre Channel port

The dual independent 4-Gb Fibre Channel ports can
connect the FibreBridge to either a Fabric or
Arbitrated Loop using a Small Formfactor Pluggable
(SFP) interface. The FibreBridge auto negotiates with
1-Gb, 2-Gb and 4-Gb/sec. devices

SCSI ports

The two SCSI ports connect storage devices into the
Fibre Channel Storage Area Network (SAN). Each
port is totally independent from the other.
The ports are Ultra320 SCSI busses with VHDCI
connectors, downward compatible with all forms of
single-ended SCSI and all previous SCSI protocols.

Management access

The 10/100 Base T Ethernet port is accessible from the
RJ-45 connector to support local and remote
diagnostics, monitoring and management.
A serial 10-pin
header provides
support for an RS-
232 remote
monitoring and
management port
through a Command
Line Interface. The baud rate is programmable and
preset at the factory to 115200 bps.

LED indicators

The on-board LED indicators show through the
faceplate and follow left to right.
a green LED indicates activity if it is lit,
SCSI ports:
no activity if it is off.
A lighted green LED indicates
Fibre Channel port:
link; off means no link. A separate green LED
indicates activity if it is lit, no activity if it is off.
Embedded in the Ethernet port connector:
lighted green LED shows a valid link; off indicates
that no link is present. A separate blinking yellow LED
indicates activity.
A bicolor Ready/Fault LED
ready, lights yellow to show a faulted condition, and is
off to indicate not ready.
a
lights green to indicate