Atto Fibrebridge 2390C; Board Dimensions; Cooling And Airflow; Power - ATTO Technology FibreBridge 2370E Installation And Operation Manual

The ATTO FibreBridge 2390C is a 4-Gigabit Fibre Channel to SCSI bridge offering the ability to add 4-Gigabit
Fibre Channel connectivity to Ultra320 SCSI storage devices.
The FibreBridge 23900C is available in an industry-
standard 4U cPCI card. Default values are appropriate
for most applications. Refer to
FibreBridge on page 15 for more information.

Board dimensions

6.1939 inches
Width:
6.299 inches
Length:
Height of tallest component:

Cooling and airflow

Operating temperature: 0-40 °C
Humidity: 10-90% non-condensing

Power

The FibreBridge
NU 5V GND 5V 5V GND
board may be
1
powered from the
cPCI backplane
connector or a 6-pin connector.
5.0V
Input voltage:
30 Watts
Power draw:
Battery-backed event log SRAM & Real-Time-
A rechargeable Lithium ion battery cell holds
Clock:
the memory in a 512KB SRAM for up to 30 days.
WARNING
WARNING
Risk of explosion if the battery is removed
and/or replaced by an incorrect type.
Dispose of used batteries in accordance
with your local environmental regulations.
Explosionsgefahr, wenn die Batterie falsch
entfernt und/oder ersetzt wird. Entsorgen
Sie benutzte Batterien in Übereinstimmung
mit Ihren lokalen
Umweltschutzbestimmungen.
If the FibreBridge becomes disconnected from power,
recharging begins automatically when power is
restored to the system. The battery is fully charged
after 24 hours of continuous power application.
7
ATTO Technology Inc. FibreBridge Installation and Operation Manual

1.3 ATTO FibreBridge 2390C

Configuring the
.545 inches
6-pin connection pinouts
2 3 4 5 6

Fibre Channel port

The 4-Gb Fibre Channel port uses a Small Formfactor
Pluggable (SFP) interface.

SCSI ports

The two SCSI ports connect storage devices into the
Fibre Channel Storage Area Network (SAN). Each
port is totally independent from the other.
The ports are Ultra320 SCSI busses with VHDCI
connectors, downward compatible with all forms of
single-ended SCSI and all previous SCSI protocols.

Management access

The 10/100 Base T Ethernet port is accessible from the
RJ-45 connector to support local and remote
diagnostics, monitoring and management.
A serial 10-pin
header provides
support for an RS-
232 remote
monitoring and
management port
through a Command
Line Interface. The baud rate is programmable and
preset at the factory to 115200 bps.

Manual reset switch

A manual reset switch reboots the FibreBridge.
To reset the FibreBridge, depress the reset button for
no more than three seconds.
To restore factory defaults, press the reset button for
more than four seconds until the green Ready LED
blinks.

LED indicators

The on-board LED indicators show through the
faceplate and follow left to right.
a green LED indicates activity if it is lit,
SCSI ports:
no activity if it is off.
A lighted green LED indicates
Fibre Channel port:
link; off means no link. A separate green LED
indicates activity if it is lit, no activity if it is off.