Atto Fibrebridge 2390R/D; Dimensions; Cooling And Airflow; Power - ATTO Technology FibreBridge 2370E Installation And Operation Manual

The ATTO FibreBridge 2390R/D is a 4-Gigabit Fibre Channel to SCSI bridge offering the ability to add 4-Gigabit
Fibre Channel connectivity to Ultra320 SCSI devices.
The FibreBridge 2390R/D is available in an industry-
standard IU form factor for easy integration into racks.
The advanced connectivity options make it suitable to
support next-generation storage media such as LTO-3
and SDLT600.
Default values are appropriate for most applications.
Configuring the FibreBridge
Refer to
for more information.

Dimensions

16.494 inches
Width:
10 inches
Length:
1.579 inches (1U)
Height:
approximately 10 pounds
Weight:

Cooling and airflow

Operating temperature:
10-90% non-condensing
Humidity:
Air enters from the front and is exhausted out the
connector side. Ambient air near the inlets should not
exceed 40 °C. The unit automatically stops operation
if the temperature goes beyond this threshold.
CAUTION CAUTION
Do not block the enclosure's vents. The
FibreBridge does not allow data transfer if
overheating occurs.

Power

The power supply circuit is permanently mounted
within the enclosure and is not hot swappable. It has
one standard IEC320 power receptacle and switch.
The universal power supply provides power for the
bridge board and cooling fan.
The power requirements of the ATTO FibreBridge
2390R plus the power draw of the other equipment in
the rack must not overload the supply circuit and/or
wiring of the rack.
110/230V AC, with operating input
Input voltage:
range of 90-132V AC or 175-264V AC, 100-240
VAC; 1.7-.7A, 50-60Hz.
5
ATTO Technology Inc. FibreBridge Installation and Operation Manual

1.2 ATTO FibreBridge 2390R/D

on page 15
0-40 °C external
Battery-backed event log SRAM & Real-Time-
A rechargeable Lithium ion battery cell holds
Clock:
the memory in a 512KB SRAM for up to 30 days.
WARNING
WARNING
Risk of explosion if the battery is removed
and/or replaced by an incorrect type.
Dispose of used batteries in accordance
with your local environmental regulations.
Explosionsgefahr, wenn die Batterie falsch
entfernt und/oder ersetzt wird. Entsorgen
Sie benutzte Batterien in Übereinstimmung
mit Ihren lokalen
Umweltschutzbestimmungen.
If the FibreBridge becomes disconnected from power,
recharging begins automatically when power is
restored to the system. The battery is fully charged
after 24 hours of continuous power application.

Fibre Channel interface

The optical SFP 4-Gb Fibre Channel port auto-
negotiates to 1-Gb, 2-Gb or 4-Gb devices.

SCSI ports

The two independent SCSI ports are Ultra320 SCSI
busses with VHDCI connector, downward compatible
with all forms of single-ended SCSI and all previous
SCSI protocols.

Management ports

The 10/100 Base T Ethernet port is accessible from the
RJ-45 connector to support local and remote
diagnostics, monitoring and management.
The RS-232 serial port provides
support for remote monitoring
and management using a DB9
connector. The baud rate is
programmable and preset at the
factory to 115200 bps.
1
6
2
RX
7
TX 3
8
4
9
GND
5