Manual Reset Switch; Led Indicators - ATTO Technology FibreBridge 2370E Installation And Operation Manual

Manual reset switch

A manual reset switch reboots the FibreBridge.
To reset the FibreBridge, depress the reset button
for no more than three seconds.
To restore factory defaults, press the reset button
for more than four seconds until the green Ready
LED blinks.

LED indicators

The LED indicators can be viewed from the connector
(back) side and the front side of the FibreBridge
2390R/D. (See Exhibit 1.2-1)
LEDs on the connector (back) side are:
A bicolor Ready/Fault LED
ready, lights yellow to show a faulted condition, and is
off to indicate not ready.
Embedded in the Ethernet port connector:
lighted green LED shows a valid link; off indicates
Exhibit 1.2-1 Fibre Bridge 2390R/D dimensions with front panel LEDs and connector side details
R eady, F ault LE D s
S erial port
lights green to indicate
a
FC A ctivity, Link LE D s
E thernet port Fibre C hannel port
R eset sw itch
that no link is present. A separate blinking yellow LED
indicates activity.
A lighted green LED indicates
Fibre Channel port:
link; off means no link. A separate green LED
indicates activity if it is lit, no activity if it is off.
A green LED on each port indicates
SCSI ports:
activity if is lit.
LEDs on the front panel are:
A bicolor Ready/Fault LED
indicate ready, lighted yellow to show a faulted
condition, and off indicates not ready.
A green LED on each port indicates
SCSI ports:
activity if is lit.
bicolor LED indicates FC
Fibre Channel port:
speed. If it is off, speed is 1-Gb; if it is green, 2-Gb,
and yellow indicates 4-Gb FC. A separate green LED
indicates activity if it is lit, no activity if it is off.
S C S I A ctivity LE D s
S C S I ports
is lighted green to
P ow er receptacle
6