Manual Reset Switch; Led Indicators - ATTO Technology FibreBridge 2370E Installation And Operation Manual

Manual reset switch

A manual reset switch reboots the FibreBridge.
To reset the FibreBridge, depress the reset button for
no more than three seconds.
To restore factory defaults, press the reset button for
more than four seconds until the green Ready LED
blinks.

LED indicators

The LED indicators can be viewed from the connector
side and the front side of the FibreBridge 2400R/D.
(See Exhibit 1.4-1)
LEDs on the connector side are:
A bicolor Ready/Fault LED
ready, lights yellow to show a faulted condition, and is
off to indicate not ready.
Embedded in the Ethernet port connector:
lighted green LED shows a valid link; off indicates
Exhibit 1.4-1 Connectors, LEDs and power receptacle
air vents
Serial port
Reset switch
lights green to indicate
a
Ready/Fault LED
FC activity & link LEDs
Ethernet port
Fibre Channel ports
that no link is present. A separate blinking yellow LED
indicates activity.
Fibre Channel port:
link; off means no link. A separate green LED
indicates activity if it is lit, no activity if it is off.
A green LED on each port indicates
SCSI ports:
activity if is lit.
LEDs on the faceplate are:
A bicolor Ready/Fault LED
indicate ready, lighted yellow to show a faulted
condition, and off indicates not ready.
A green LED on each port indicates
SCSI ports:
activity if is lit.
Fibre Channel port:
speed. If it is off, speed is 1-Gb; if it is green, 2-Gb,
and yellow indicates 4-Gb FC. A separate green LED
indicates activity if it is lit, no activity if it is off.
on the connector side and LEDs on the faceplate
SCSI activity LEDs
SCSI ports
A lighted green LED indicates
is lighted green to
bicolor LED indicates FC
Power receptacle
10