Ascii; Settings For Serial Port (Option Spt) - Ametek AN-3100D Installation And Configuration Manual

ASCII

The only setting required for ASCII Protocol is to enable the Serial Comms Port.

Settings for Serial Port (Option SPT)

Note: The Serial Comms Port selection must be one of; ASCII, Modbus, or DNP.
Turning on ASCII Serial Comms turns off Modbus and DNP Serial Comms
Parity
The parity for the serial communications may be selected from:-
None
Odd
Even
The configuration application will always use the parity defined for the AN-
3100D. If the parity is changed it will not take effect until the current
configuration session is complete.
Baud Rate
The ASCII baud rate may be selected from :-
1200
2400
4800
9600
19200
The configuration application will always use the baud rate defined for the AN-
3100D. If the baud rate is changed it will not take effect until the current
84 AN-3100D ANNUNCIATOR INSTALLATION AND CONFIGURATION MANUAL