Pushbutton Controls - Ametek AN-3100D Installation And Configuration Manual

P
USHBUTTON
Pushbutton activation can be transmitted from the Annunciator via a Binary input
to indicate whenever a pushbutton is activated locally at the Annunciator.
(Reference the Binary Input Data Map for location of the pushbutton indications.)
Pushbutton controls can be sent to the Annunciator using a Control Relay
Output block, as detailed below.
Control Relay Output Block (Object 12, variation 2)
Object
Index #
Numbe
00
01
For proper pushbutton operation, transmit a single LON (latch on) followed
by a single LOFF (latch off). Allow a few seconds in between commands to
ensure the Annunciator receives the pushbutton controls.
Mode: Direct
The Pushbutton Control Status can be checked by issuing a Binary Output
Status, Object 10, variation 2.
Binary Output Status (Object 10, Variation 2)
Index #
00
01
AN-3100D ANNUNCIATOR INSTALLATION AND CONFIGURATION MANUAL
C
ONTROLS
DNP Object
Variation
r Number
10 02
10 02
16 Bit Index
DNP Object
Object Variation
Number Number
10 02
10 02
Control Code
LON,
Reset Pushbutton
LOFF *
LON,
Acknowledge Pushbutton
LOFF *
Description
Reset Pushbutton
Acknowledge Pushbutton
i.
Description
117